Service Manual For CHERY QQ6 (Maintenance And Care) After Sales Service Department of Chery Automobile Sales Co., Ltd
A complete seiral number for a transmission is as follows: * □ □ □ □ ○○○○○ *
3). Example For example: QR513MHA MH5H00001 means the first model QR513MHA transmission manufactured in August 2005. Chapter 2 Technical Specifica
2. Oil/Fluid Capacity Table Engine Oil (Including strainer) SQR473F series: 4.0L±0.5 L SQR472F series: 3.5 L M/T (Manual Transmission) QR513MHA: 1.8±
Chapter 3 Basic Operation and Adjustment 1. Vehicle Delivery Check 1.1. Interior and exterior (1) Interior and appearance defects (2) Paintwork, ele
(3) Working condition of front wiper (4) Turn signal indicator lamps and its automatic releasing (5) Working condition of side lamps and number plate
1.8. Vehicle uplift check (1) The wear or damage of bottom, engine, brake and fuel pipes (2) Suspension fixing and its bolts (3) Transmission oil lev
2.2. Position of rear jack lift point The rear jack lift point is located at the convex edge of the lower rear part of the vehicle, 10 cm away from
3.1.2. Rear tow ring The rear tow ring is located under the rear of body, as shown in the figure below: 3.2. Towing method 3.2.1. The vehicle with m
4.2. Mileage setting The upper right of the odometer displays the one-way mileage (switchable), and the lower right displays the total mileage. In the
The air bag is an optional configuration. If your vehicle is equipped with the air bags, please ensure that there is clean and no damage in the “air
TABLE OF CONTENTS Chapter 1 Overview of Vehicle...
Note: Please refill the engine oil conforming to the CHERY’s specifications only to the level between MIN and MAX marks. 8. Transmission Oil Check 8
10. Lubrication and Maintenance of All Hinges and Door Locks All the hinges and door locks are the maintenance-free products. Please make certain that
12. Coolant Check QQ6 engine has a main radiator and an auxiliary radiator. Check whether the auxiliary radiator’s coolant level is between the MAX
winter, but also provide the corrossion protection all the year around. Now, the engine can operate under very high temperature but the bad coolant ca
14. Tire Check 14.1. Pattern depth check The related regulations specify the depth of the tire surface. When the remaining depth of tire pattern rea
timing belt pulled side, when the timing belt is pressed down approx. 5 mm by hand, the force required is: 19.6 - 29.4 N (2.0 - 3.0 kg), and its schem
with brake master cylinder. 18.2. Disc brake 18.2.1. Thickness of brake disc The standard thickness of front brake disc (ventilation disc) shall be
subframe (left) Nut 2 Used to secure the tie rod and steering knuckle 35±3 Bolt 2 Lower swing arm and subframe connecting rod (left, right) 100±10 Fla
20. Check and Maintenance of Intake and Exhaust Systems Check the cleanness of air cleaner element, and replace it as required; Check the leakage and
23. Check and Maintenance of A/C System In case of the maintenance of the vehicle A/C system, the following procedures shall be conducted: first, list
4.3. Maintenance indicator light reset...18 5. Battery Check...
pipes and joints at the low pressure end. Touch the high pressure area, especially the metal parts at the high pressure end, such as compressor’s exha
air cleaner and then replace the element, and then reinstall the air cleaner after the replacement of the element. Engine oil filter Fully drain ou
conforming to the specifications in the table below, please properly adjust the wheels. Item Parameter Model SQR7130S21 SQR7110S21 Front Camber An
instruement panel shall flash; 26.6. Stop lamp: In case that the stop lamp switch is stepped on, the stop lamp and high mount stop lamp shall light
Mileage (Km) Maintenance Item 5000 15000 30000 Engine oil: Replace it ★ ★ ★ Oil cleaner: Replace it ★ ★ ★ Transmission oil: Check the oil level
Mileage (Km) Maintenance Item 5000 15000 30000 Exhaust system: Check its leakage and damage, adjust or replace it, if necessary ★ ★ Steering syst
compartment; and then lift up the vehicle and check the leakage of transmission oil viewing from the bottom of vehicle; 2.1.6. Check the oil/fluid: C
2.2. Standard 15,000 KM maintenance work procedure 2.1.1. Receive the vehicle to be maintained, wear the “four-piece series” (seat cover, steering whe
2.2.19. Brake hose: Check its ageing and damage; 2.2.20. Brake pipe: Check its damage, corrosion and the leakage of all joints; 2.2.21. Check the su
2.2.35. Seat belt: Check its damage; 2.2.36. Trial driving: Check the display status of combination instrument, the working condition of four-door reg
Chapter 1 Overview of Vehicle 1. Overview of Engine The QQ6 car is equipped with a engine of 1.3L or 1.1L displacements which is developed and produc
2.3.19. Hand brake: Check its travel, and regulate it, if necessary; 2.3.20. Tire position change: Change the position of tires according to the descr
wheels at the timing belt pulled side, when the timing belt is pressed down approx. 5 mm by hand, the force required is: 19.6 - 29.4 N(2.0 - 3.0 kg);
3.1.2. Meaning of VIN code 1) The VIN code is structured according to the requirements of GB16735. □□□ □□○○□○ □○ ○○○○○○ World Manufac
② The second character of VIS section represents the plant of manufacture. The CHERY Automobile Co., Ltd. is represented as the character D. ③ The th
□□□ ○ ○○ □ □
Co., Ltd., which is a four-valve multipoint injection engine (the line gasoline engine feature code “L” is omitted and then is occupied by the “four-v
3.3. Transmission Number 3.3.1. QR513 series transmission nubmer position The position of QR513 series transmission number is as shown in the figure:
Comments to this Manuals