11.14 Double Brake Switch
Failure codes: P0571, P0504
No. Operating steps Result Follow up steps
1 Put the ignition switch to “ON”. Next step
Yes Next step 2 Pull out brake switch joint on harness, and then
use a multimeter to check if it is short or break
circuit between 1#, 2# pins of this joint and 21#,
58# pins of ECU.
No Check the circuit
Yes Next step 3 Close the ignition switch, and then check if an
around 12V battery voltage is present on 3# pin of
the switch joint.
No Check the circuit
Yes Next step 4 Open the ignition switch, and then check if an
around 12V battery voltage is present on 4# pin of
the switch joint.
No Check the circuit
Yes Next step 5 Release brake pedal, disconnect sensor connector,
and then check if 1# and 3# pins cut off.
No Replace the brake
switch
Yes Next step 6 Release brake pedal, disconnect sensor connector,
and then check if 2# and 3# pins conducts.
No Replace the brake
switch
Yes Next step 7 Apply brake pedal, disconnect sensor connector,
and then check if 1# and 3# pins conducts.
No Replace the brake
switch
Yes Check other part 8 Apply brake pedal, disconnect sensor connector,
and then check if 2# and 4# pins cut off.
No Replace the brake
switch
Comments to this Manuals