search

Chery QQ Service Manual Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 70
  • Table of contents
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 43
CHERY·A21 SERVICE MANUAL ENGINE EFI SYSTEM
44
cableor to power supply between relay control ends that is
relay pin No.85 and ECU pin No.69.
No Diagnosis help
DTC: P0325 Knock sensor circuit failure
No. Operating steps Result Follow up steps
1
Connect the diagnostic tester and commutator, put the
ignition switch to “OFF”
Next step
Yes Next step
2
Take off the knock sensor joint from the cable; check
the resistance value by multimeter between knock
sensor connector No.1and No.2 and observe if it is
1MΩ.
No Change sensor
Yes
Repair or replace
the cable3
Check if there is open circuit or short circuit to ground
or to power supply between circuit of knock sensor
joint No.1, No.2 and ECU pin No.19, No. 20
No To step No.2
Yes Diagnosis help
4
Replace the knock sensor according to the regulation;
try running the vehicle and make the engine speed
exceed 2200rpm. Check if the DTC P0325 will appear
again.
No
Check if it is a
occasional fault
DTC: P0335 Crank shaft position sensor signal failure
No. Operating steps Result Follow up steps
1
Connect the diagnostic tester and commutator, put the
ignition switch to “OFF”
Next step
Yes Next step
2
Take off the speed sensor joint from the cable; check
the resistance value by multimeter between speed
sensor connector No.2and No.3 and observe if it is
around 770-950MΩwhen it is 20℃
No Replace sensor
Yes
Repair or replace
the cable3
Check if there is open circuit or short circuit to ground
or to power supply between circuit of speed sensor
joint No.2, No.3 and ECU pin No.34, No. 15
No Next step
Yes Diagnosis help
4
Check the flywheel signal disc if it is in good
conditions.
No
Replace signal
disc
DTC: P0336 Crank shaft position sensor signal unreasonable failure
No. Operating steps Result Follow up steps
1
Connect the diagnostic tester and commutator, put
the ignition switch to “OFF”
Next step
Yes Next step
2
Take off the speed sensor joint from the cable; check
the resistance value by multimeter between speed
sensor connector No.2and No.3 and observe if it is
around 770-950MΩwhen it is 20℃
No Replace sensor
http://WWW.FORA-CLUB.RU
Page view 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

Comments to this Manuals

No comments
Related products and manuals for Cars Chery QQ
Cars Chery QQ6 Service Manual   (41 pages)
Cars Chery S18D Service Manual   (69 pages)
Cars Chery QQ6 Service Manual   (85 pages)
Cars Chery QQ6 User Manual   (37 pages)
Cars Chery SQR477F User Manual   (3 pages)
Cars Chery Tiggo 2009 User Manual   (1 pages)
Cars Chery SQR7240 User Manual   (32 pages)
Cars Chery RIICH 2 series User Manual   (14 pages)
Cars Chery S18D User Manual   (19 pages)
  • Epox-computer Commercial cool Alien Starbucks Barista Yurex
  • Highpoint Interface cards/adapters Targus Cable interface/gender adapters Philips Digital photo frames Holley Unknown Maytag Unknown
  • EnGenius M36 Samsung GT-S3850 La-crosse-technology 308-1451 Samsung WD80K5400OW/EG Black-decker CJ630
  • Olympus IPLEX UltraLite User Manual Sony PCG-TR2A User Manual Samsung SyncMaster S27B550V User Manual AEG FSB51400Z User Manual