Chery QQ Service Manual Page 68

  • Download
  • Add to my manuals
  • Print
  • Page
    / 70
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 67
CHERY·A21 SERVICE MANUAL ENGINE EFI SYSTEM
68
12. React slowly when it is accelerated.
General failure component: 1) water in fuel; 2) air intake pressure sensor and throttle
position sensor; 3) spark plug; 4) throttle valve and idle speed by pass port; 5) air intake
port; 6) idle speed regulator; 7) injector; 8) ignition timing; 9) exhaust pipe.
General diagnosis flow:
No. Operating steps Result Follow up steps
Yes
Repair the air
intake system
1 Check the air cleaner if it is jammed.
No Next step
Yes Next step
2
Connect the fuel pressure meter ( connecting point is the
front end of fuel distributing pipe assembly fuel intake
pipe); start the engine and check fuel pressure at idle speed
if it is around 260kpa; take off the vacuum pipe from fuel
pressure regulator check the fuel pressure if it is around
300kpa.
No
Repair the fuel
supplying
system
Yes Next step
3
Check spark plugs in every cylinder and observe its type
and clearance if it is accord with the regulation.
No
Adjust or
replace
Yes
Clean related
part
4
Disassemble idle speed regulator and check throttle valve,
idle speed regulator and idle speed by pass port if there is
carbon deposition.
No Next step
Yes Next step
5
Inspect air intake pressure sensor, throttle position sensor
and its line if it is working correctly.
No
Repair line or
replace sensor
Yes
Replace fault
part6
Disassemble the injector, check the injector using the
injector special cleaning analysis meter and observe if it is
leaking or jammed.
No Next step
Yes Replace fuel
7
Check fuel conditions and check if the failure is appeared
after the fuel refilling
No Next step
Yes Next step
8
Check the engine ignition order and ignition timing if it is
accord with the regulation.
No
Repair ignition
timing
Yes Next step
9 Check the exhaust pipe if the air exhausting is smooth
No
Repair or
replace exhaust
pipe
Yes Diagnosis help
10
Connect EFI system adaptor, turn on the ignition switch;
check the power supply of pin No.12, 13, 44, 45 and No.63
if it is in right conditions; check pin armature of No.3, 51,
53, 61 and No.80 if it is in right conditions.
No
Repair
corresponding
line
http://WWW.FORA-CLUB.RU
Page view 67
1 2 ... 63 64 65 66 67 68 69 70

Comments to this Manuals

No comments