Chery QQ User Manual download pdf (Page 106)

Emergency situation

97

Start engine by jumper

wire

The battery from other vehicle may be

used to start engine if vehicle battery is

not charged enough to start vehicle. Any

improper operation may result in battery

explosion, personal injury or property

damage and cause vehicle electric system

failure to a certain extent.:

-Do not have battery near open fire or

spark

-Do not have battery electrolyte contact

eye, skin, fabric or lacquer finish.

Electrolyte contains sulphuric acid which

may cause injury by direct contact.

-Wear protective glasses when operating

near battery in order to decrease the

danger of being harmed.

-Ensure that the battery from vehicle for

starting has the same voltage (12V) with

the original battery

-Do not disconnect battery which is not

well charged.

-Shut electrical load which is not

necessary.

-Do not bend over battery during starting

by jumper.

-Do not have two leads for starting

shorted.

-Apply hand brake and put transmission

control lever in neutral gear. Connect one

end of the first jumper to the positive pole

(there is "+" mark on battery box or

terminal) on the following method

-Connect the other end of the jumper to

the positive pole ("+" mark) of the battery

which is not well charged

-Connect one end of the second jumper to

the negative pole of the battery which is

from other vehicle( marked with " - ").

-Connect the other end of the second

jumper to the engine body or engine

supporting screw of another vehicle. Do

not connect jumper to the negative

terminal of the battery which is not well

charged. Connection points should be

away from the battery which is not well

charged as far as possible. Position

jumpers properly avoid contacting the

moving parts of engine compartment.

-The vehicle which offers battery source

may run during jumper start. The vehicle

with battery not well charged should be

started within 1 minute

Emergency situation

And continuous starting time is not

allowed to be more than 12 seconds.

Connection should be disconnected once

engine is started.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 183 184

Comments to this Manuals

No comments