Emergency Assistance
DO NOT touch these components
in the case of the engine operating
or the ignition switch turning on.
Disassemble and install
Take care to apply the following
preventive measures when the battery
is disassembled and installed.
Your vehicle is equipped with a
12 V, 75 A•h, maintenance-free
lead and acid battery.
The old battery must be replaced
with a new lead and acid battery
when replacing the battery. Do
not use the other kinds of
batteries. The current and
capacity of the new battery must
be the same as that of the old
battery or conform to the
specification of the Chery
Company. For the right, detailed
specification of battery, please
enquire the Chery Authorized
Service Station.
Please remove the negative (-)
cable firstly after the ignition and
all electrical equipment are turned
off.
Please operate carefully and avoid
that the metal tools contact the
two electrodes of battery
simultaneously or contact the
positive electrode and the vehicle
body by accident.
When connecting the battery
again, you shall connect the
positive (+) cable firstly, and then
the negative (-) cable.
After the battery is subject to
disassembly and reconnection, the
vehicle may be indicative of some
abnormal performances during
the initial stage of driving. This is
that the engine control system is
being adapted to the engine, and
you can go unheard.
The used battery contains
sulfuric acid and lead. DO
NOT discard the battery according to
the requirement of general domestic
waste. Please send it to the local waste
disposal station qualified.
Comments to this Manuals