Chery QQ6 Service Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 85
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
gases as carbon dioxide and water etc. At 300-800, the conversion efficiency of three -way
catalytic converter is maximum; with a temperature below this scope, the conversion efficiency will
be very poor, while, with a temperature above this scope, the three-way catalytic converter may be
burnt out. Three-way catalytic converter can exert better conversion efficiency only when the
oxygen sensor works. In control strategies of ECU, there are several protective modes for three-way
catalytic converter, and ECU can protect the three-way catalytic converter by regulating air-fuel ratio
and ignition advance angle.
15. Fan Control
15.1 Function:
In order to abstract heat from engine system and from condenser with A/C turned on, fan
control is affected by the signal to ECU sent by water temperature sensor; When water temperature
is high (above the threshold value set by ECU), the fan will run, and when water temperature is low
(below the threshold value set by ECU), the fan will also run; with A/C turned on, the fan will run at
low speed.
15.2 Composition:
DC electric motor double fan (high and low speed change).
15.3 Installation requirements:
The fan is installed between the rear of radiator and the engine, be careful when installing: not
to damage fin of fan blade, otherwise, running noise of the fan will increase, if serious, it may lead to
sharp fall of heat radiation effect of the engine.
15.4 Failure diagnosis:
Fan control circuit is a short or open circuit to ground;
The fan has failure itself;
Too loud fan noise;
Failure in power supply circuit of fan.
15.5 Troubleshooting:
First, validate whether it is a high speed fan system problem or a low speed fan system problem.
Provided that this is a fan control system problem, use a diagnostic tester to locate the failure point,
and then validate whether it is a short-circuit or a break in control circuit.
Failure symptom: the fan failure may result in rise of engine coolant temperature and poor
refrigeration of A/C system.
15.6. Fan Control:
Turn-on of low gear of fan:
1. Temperature of engine coolant: 96-102;
2. On request for A/C, the fan will start up;
3. When driving speed is too high, the fan will start up;
High speed startup of fan:
1. Engine coolant temperature sensor failure;
2. Air flow meter failure;
3. Engine coolant temperature exceeds 102.
Pins:
Main relay
High speed
relay of fan
Low speed
relay of fan
Brief sketch map of fan control
Fan motor
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 84 85

Comments to this Manuals

No comments