Chery QQ6 Service Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 85
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
signals fed back by the oxygen sensor, i.e. control injection pulse-width to let the mixed gas always
maintain an approximately ideal air-fuel ratio (14.7:1).
7.2 Principle of the sensor:
Sensing element of oxygen sensor is a kind of ceramic tube with holes, and outside of tube
walls are surrounded by engine exhaust gas and inside is air. Ceramic sensor element is a kind of
solid state electrolyte with electrical heating tube inside (as shown in the figure).
The operation of the oxygen sensor is achieved by converting the concentration difference of
oxygen ion between inside and outside of the ceramic sensor element to the voltage signal output. It
bears the characteristic of solid electrolyte once the temperature of the ceramic sensor element
reaches 350. Because of the particularity of its materials, the oxygen ion can pass the ceramic
sensor element freely. Taking advantage of this characteristic, the concentration difference will be
converted to electric potential difference to form electric signal output. If the mixed gas is
comparatively thick, the oxygen ion thickness difference between inside and outside of the ceramic
tube will be higher and the potential difference will also be higher, then a mass of oxygen ion will
move from inside to outside, so, the output voltage is comparatively high (close to 800mV-1000mV);
If the mixed gas is comparatively thin, the oxygen ion thickness difference between inside and
outside of the ceramic tube will be smaller and the potential difference will also be smaller, then just
a few of oxygen ion will move from inside to outside, so, the output voltage is comparatively low
1. Cable 2. Dish washer 3. Insulation bush 4. Protective bush
5. Clamp fitting of heating element 6. Heating rod 7. Contact pad
8. Sensor seat 9. Ceramic probe 10. Protection sleeve
Cross-section view of oxygen sensor
Characteristic Curve of oxygen sensor at 600°C
Output voltage V
Excessive air-fuel ratio λ
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 84 85

Comments to this Manuals

No comments