Chery TRITEC1.6L Specifications download pdf (Page 60)

11 7

11 8

620

Safety-check before Driving

You' d better carry out a safety-check

before driving the vehicle. A check for

minutes will be beneficial for your safe

and enjoyable driving.

Check before Starting the

Engine

Note

In case of a check in a closed garage,

make sure that the garage is well

ventilated. The waste gas exhausted

from the engine is harmful.

The outer vehicle

Tire: Check the tire pressure with

a tire pressure gauge and check

carefully if there is cut, damage or

excessive wear.

Wheel nuts: Make sure no looseness

or loss of nuts.

Illum ina tion : Make sur e that the head light ,

brake lam p, posi tion lam p, st eer ing

indi cat or lam p and ot her illum inat ion all

work. Check the aiming of the head light .

The inner vehicle

Spare tire, jack and wrench for wheel

nuts: Check the pressure of the spare

tires and make sure there is a jack and

wrench for wheel nuts.

Seat belt: Check if the buckle can be

tightly fixed and make sure there is

no wear nor scratch on the belt.

Instrum ent and controll er: Speci ally

make sure that indica tor, inst rument

illumination and defrost er work normally.

Brake: Make sure that there is enough

free clearance for the pedal and ensure

a normal braking.

The inside of the engine compartm ent

Spare fuse: Make sure there are fuses

of all specifications for rating carrying

capacity in the fuse box.

Coolant level: Make sure that the coolant

level is correct (refer to the instruction in

Section 7-2).

Battery and cable: Check if there is

any corrosion, looseness or crack at

the harness connector and check if the

cable and connection is good.

Harness: Check if there is damage or

looseness to the harness.

Fuel pipe: Check if there is leakage and

looseness at the pipeline joint.

Driving Guidance under Different Situations

After the engine starts

Exhaust system: Check if there is

gas leakage. In case of a leakage,

immediately repair it (refer to

“Engine Exhaust in

Chapter 2) .

Warning”

During driving

Instrument: Make sure that indicators

and gauges of all kinds in the

instrument cluster work normally.

Brake: Find a safe place and make

sure that the vehicle does not pull to

one side when braking.

Pay attention to the initial stage and

check carefully if there is abnormal

noise.

1. Stopping the vehicle

The vehicle should not be stopped at

once when the engine is working,

especially at a high rotation speed with

high load. It should be stopped after 3-5

minutes low-speed run.

2. Rainy day or wading through water

3. Warming the engine in winter

Make sure that the air cleaner has been

sealed well when running on the road with

seeper in rainy days or wading through

water in normal times; otherwise, the

water may enter the engine cylinder

and cause damage to the components

such as engine connecting rod.

In winter with relatively low temperature,

the viscosity of oil will increase and its

lubrication effect is worse than that in

summer. Therefore, the engine should

not work under large load at high speed

immediately after it is started. It should

be warmed for minutes at idle speed to

increase the temperature of the oil and

●Drive slowly against the wind. It is

convenient for controlling vehicle.

●Drive slowly on the ashlar at the side

of street and keep the correct angle as

possible as you can. Avoid driving on

high and sharp-edged objects or other

road barriers; otherwise the tire will

be damaged abnormally.

●Decelerate when driving on a bumpy

road; otherwise the tire or wheel will

be seriously damaged.

●If the vehicle is parked on the hillside,

rotate the front wheels to make them

contact the roadside and use the parking

brake to make them not slip. If necessary,

place a crosstie under the wheels.

Oil level: Park the vehicle on flat ground

and check if the oil level is correct.

(Refer to the instruction in Section 7 -2).

Leakage: Check if there is leakage of

oil or liquid under the vehicle after

the vehicle stops for a while. (It is

normal in case of drips from A/C in

operation.)

coolant. Only after the engine is fully

lubricated, can you drive the vehicle.

In case of driving when the engine is

not well lubricated, the components of

the engine may suffer from over wear

or even be locked.

Instru cti on Manual of Lifan Sedan

LIFAN

Instru cti on Manual of Lifan Sedan

LIFAN

Chongqing Lifan Passenger Vehicle Co., Ltd.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 87 88

Comments to this Manuals

No comments

Chery TRITEC1.6L Specifications Page 60

Comments to this Manuals

Related products and manuals for Cars Chery TRITEC1.6L