Chery TRITEC1.6L Specifications download pdf (Page 70)

13 7

13 8

Anti-corrosive on Vehicle Body

620

A corre ct maintenance of the vehicle

can protect it fro m corro sion for long.

Most common causes for vehicle

corrosion:

●The underside of vehicle is covered

with salt and alkali, dust and moisture.

●Protective paint cover scratched by a

light collision or stone and grit.

It is essential to take an extra care

in case of living in a special region

or operating the vehicle under

special environment.

●The salt and alkali or dust with chemical

materials on the road will accelerate the

corrosion. Even in the coastal area or

industrial pollution region, there is still

salinity in the air.

●A high humidity will accelerate the

corrosion, especially in case of a

temperature barely above zero.

●A cer tain par t of the veh icle bei ng wet or

dam p for a long time will be cor roded,

although ot her par ts kee p dr y.

●A high room temperature will cause

corrosion to the vehicle components

which can not get dry fast due to the

lack of correct ventilation.

The above shows that it is very important

to keep the vehicle clean as much as

possible, especially the bottom of the

vehicle body, and repair the damaged

paint and protection layers as soon as

possible.

Follow the rules below to prevent

LF620 from corrosion:

Always clean the vehicle: A regular

cleaning may keep the vehicle body

clean. Please abide by the following

rules to avoid corrosion.

●Clean the running part of the vehicle at

least once each month to avoid corrosion

in case of driving on the road with salt

and alkali in winter or at coastal areas.

●High-pressure or steam is very effective

for cleaning the chassis and wheel cover.

It is hard to see all the slurry and dirt in

those two places. Therefore, an extra

attention must be paid. It will cause more

serious danger in case of only roughly

moistening but not cleaning the slurry and

chips. The drain holes of door lower brim,

doorsill plate and the vehicle frame

must not be obstructed by dust;

otherwise the seeper in those parts will

cause corrosion;

●Completely clean the chassis after winter.

Check the paint and trims: In case of

any fragment or crack on the paint layer,

please immediately go to the

station for repair to prevent corrosion.

In case of fragment or crack falling off

the metal surface, please go to the

station for repair.

Lifan service

Refer to “Vehicle Cleaning and Waxing”

for more details.

Vehicle Cleaning and Waxing

1. Wash away the loose dirt by a water

pipe, and wash away all the slurry on the

vehicle bottom and depressed part of

the wheel or the salt and alkali on the

road.

2. Clean the vehicle with neutral cleaning

solution. The mixture of cleaning solutions

should be carried out according to the

instructions of the manufacturer. Dip a

soft cloth with cleaning solution and wipe

away the dirt by suds and clean water. Do

not wipe it forcefully.

Check the inner vehicle compartment:

The moisture and dust covering the floor

mat will cause corrosion. Please always

check the place under the mat and make

sure it is dry. Take an extra care during the

transportation of chemicals, cleanser,

fertilizer, salt and other materials which

should be transported by proper containers.

In case of any spill or leakage, please

immediately clean and keep it dry.

Park the vehicle in a fully-ventilated garage

or a place with roof. Do not park it in a damp

and airproof garage. The garage will become

damp due to cleaning vehicle in it or the

vehicle driving through a seeper or snow road,

resulting in corrosion. Although the garage

is very dry, bad ventilation will also cause

corrosion to a damp vehicle.

Cleaning Lf620

Clean the car in normal way.

The following cases will cause the paint

layer to fall off or result in corrosion to

the vehicle body and components.

Please immediately clean the vehicle

and repair that.

●Driving in the coastal region

●Driving on the road covered with

antifreeze.

●Stuck by coal tar, resin, ornithocopros

and dead insects

●Driving in a region with a great deal of

soot, coal ash, dust, scrap iron or

chemical materials

●Being evidently dirtied by dust and slurry

Manual cleaning of LF620

Clean the vehicle after its body feels not

hot in a shady place.

Note

Be careful not to hurt your hands when

cleaning the underside of the floor or

the chassis.

Warning

Do not install the seriously damaged

plastic wheel trims; otherwise, the

wheel trims will fly off the wheel

and cause an accident during

driving.

Application of mudguard: The mudguard

can protect the vehicle in case of driving

in salty and alkali region or on gravel roads.

It is better if the mudguard is bigger and

closer to the ground. The wheel house

mudguard for LF620 is optionally installed.

This installation service is available at the

service station.Lifan

Instru cti on Manual of Lifan Sedan

LIFAN

Instru cti on Manual of Lifan Sedan

LIFAN

Chongqing Lifan Passenger Vehicle Co., Ltd.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 87 88

Comments to this Manuals

No comments

Chery TRITEC1.6L Specifications Page 70

Comments to this Manuals

Related products and manuals for Cars Chery TRITEC1.6L