Chery TRITEC1.6L Specifications download pdf (Page 80)

620

620

Check the oil level

When the engine is under working

temperature, shut down the engine,

check the oil level with oil rule.

1. To obtain correct reading, it is necessary

to park the car at flat ground, shut down the

engine and wait for several minutes, let the

oil gather at the bottom of engine.

2. Pull out the oil rule and clean its end.

3. Insert the oil rule again, and try to stick

it to the bottom, or else the reading is

inaccurate.

4. Pull out the oil rule and check the oil level.

Note

Noted that not drop any oil on the

components of the car.

If the oil level is below or just a little above

the low level, it is necessary to fill the oil

of the same type.

Take off the oil filler cap, fill small

quantities of oil every time and check the

oil rule.

When the oil level reaches the right range,

put on the filler cap and screw it down.

Note

●Avoid overfilling, or the engine will be

damaged.

●When the filling is finished, recheck the

oil level on the oil rule.

●Insufficient oil will cause under-pressure

of engine oil, resulting in poor lubrication,

bringing about intensified we ar and poor

cooling of engine, causing frequent troubles

and affecting the service life of engine.

Low level

High level

To fill

Correct

Overfilled

Check the engine coolant level

When the engine is under cooling state,

check the coolant level in the reservoir, if

it is between the marking lines of “FULL”

and “LOW”, it conforms to the

requirements. If the oil level is on the low

side, it is necessary to fill coolant. (For the

type of engine coolant, refer to the

“selection of coolant type”below.)

The coolant level in the reservoir will change

along with the temperature variation, however,

if the level is at or below the“LOW”line,

it is necessary to fill coolant, to make the

level reach the “FULL”line.

After filling coolant, if the level of coolant

declines within a short time, then some

leakage exists in the system. It is

necessary to check the radiator, hose,

radiator cap, drain plug and water pump.

If no leakage is found, it is necessary to

test the cap pressure and check whether

there is any leakage at the

.

Lifan service

station

Warning

To avoid burns, when the engine is

at hot condition, don't take off the

radiator cap.

Selection of coolant type

Only use the coolant designated by Lifan,

it is necessary to fill proper type of coolant

into the cooling system as per the ambient

temperature.

Note

Don't just use clean water.

Use of improper coolant will damage

the cooling system of engine.

For details, contact the service

station .

Lifan

Warning

It is necessary to obtain enough coolant for

the cooling system to ensure the normal

operation of engine, or“boiling”of car

will occur. Whe n the engine is wo rking

under overheated condition, the service

life will be affected, so much as resulting

in bad accidents like engine scraping.

15 7

15 8

Instru cti on Manual of Lifan Sedan

LIFAN

Instru cti on Manual of Lifan Sedan

Instru cti on Manual of Lifan Sedan

LIFAN

Chongqing Lifan Passenger Vehicle Co., Ltd.

Chongqing Lifan Passenger Vehicle Co., Ltd.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 86 87 88

Comments to this Manuals

No comments